Home / Blog / Romsey evaporative cooler service

Job story · Romsey · Evaporative cooling

Evaporative cooler service and new filter pads in Romsey

This rooftop evaporative cooler in Romsey was booked in for a service before summer. The filter pads had rotted, so the job became a full strip, clean and new pads.

Written by Curtis, Macedon Ranges Gas & Air · Job completed 5 October 2026 · Published 17 November 2026

Evaporative cooler on a tiled roof in Romsey with new filter pads fitted around the fan
The finished job: new filter pads fitted on all four sides.
Where
Romsey
Home
Tiled-roof house, cooler on the roof
System
Coolbreeze evaporative cooler
Work done
Full service and new filter pads

What we found

With the covers off, the inside of the cooler was coated in dust and scale, and the filter pads were finished. They had rotted and crusted over with mineral build-up, which is what happens when pads sit wet and dirty for a few seasons.

Pads in that state can't be cleaned back to health. Air struggles to get through them, they hold less water, and the cooler ends up moving warm, stale-smelling air through the house. They needed replacing, so we ordered a new set for this model and came back to fit them and finish the service.

Inside of an evaporative cooler before cleaning, with dust and scale over the fan housing, pump and tray
Before: dust and scale through the fan housing and tray.
Old evaporative cooler filter pad lying on roof tiles, rotted and crusted with white mineral scale
One of the old pads: rotted and crusted with scale.

What we did

  • Removed the old filter pads and cleaned the unit out thoroughly
  • Fitted new filter pads on all four sides
  • Tested and checked every component to make sure the cooler runs as it should
  • Tightened the fan motor collet
  • Lubricated the damper motor rollers
  • Hand-tested the fan motor to make sure it wasn't overheating
  • Ran the cooler after the service and left it in working order
Evaporative cooler part way through cleaning, with the fan housing washed and cleaning foam in the tray
Part way through the clean, pads out and the tray foamed.
New filter pads fitted to an evaporative cooler on a tiled roof
After: clean unit, new pads in.

Written by Curtis, Macedon Ranges Gas & Air. Put together from the job notes and the photos our technician took on the day. Every photo on this page is from this job.

If your cooler is due before summer

An evaporative cooler works by pulling outside air through wet pads. If the pads are blocked or falling apart, the whole system suffers, however good the fan and pump are. A service before the hot weather is when problems like this get found, while there is still time to order parts.

Want your evaporative cooler looked at?

Our own team services and repairs evaporative coolers across the Macedon Ranges.

Book a service Call 1300 369 400