Home / Blog / Sunbury Brivis evaporative cooler

Job story · Sunbury · Evaporative cooling

New Brivis evaporative cooler installed in Sunbury

A new Brivis evaporative cooler went onto this Sunbury roof in early November. The wall controller and three of the ceiling vents were replaced at the same visit, so the system was ready before the hot weather.

Written by Curtis, Macedon Ranges Gas & Air · Job completed 6 November 2026 · Published 17 November 2026

Inside a new Brivis evaporative cooler in Sunbury with water running down through the filter pads into the tray
The new Brivis cooler on its test run, with water running through the pads.
Where
Sunbury
Home
Tiled-roof house, cooler on the roof
System
Brivis F66DS evaporative cooler
Work done
New cooler, wall controller and three ceiling vents

What went in

  • Brivis F66DS evaporative cooler fitted on the roof
  • New Brivis wall controller
  • Three ceiling vents replaced: two large six-way vents and one smaller vent for a bedroom
New Brivis wall controller fitted on an interior wall
The new Brivis wall controller.

Running it before we left

Before we packed up, the cooler was run with one side open so we could see the water flowing down through the pads and collecting in the tray. An evaporative cooler only cools properly when every pad is wet, so this is the check that matters. The photo at the top of this page was taken during that run.

Written by Curtis, Macedon Ranges Gas & Air. Put together from the job record and the photos our team took on the job. Every photo on this page is from this job.

Is your evaporative cooler ready for summer?

If your cooler is getting old, noisy or not cooling like it used to, these pages will help you work out whether to repair it or replace it. Every install we do comes with our 9 Year Labour & Workmanship Warranty.

Need a new evaporative cooler before summer?

Our own team installs and replaces evaporative coolers across the Macedon Ranges.

Ask about an install Call 1300 369 400