Evaporative Cooling Service and Repairs in Bulla
Township and acreage coolers around Bulla and Wildwood, cleaned, checked and tested by our own technicians before the heat arrives.
This week's website offer ends in
This week's website offer ends Monday 5:00 am, Melbourne time.
Prefer to talk? 1300 369 400
- Fully in-house technicians
- Experienced across all major evaporative brands
- Thorough clean and full function test
- Real footage from our own services
Real footage
See what a proper evaporative service looks like
Real footage from evaporative services completed by our own team. Foam, clean, rinse, test.
-
1 Foam
The foaming solution goes into the tank and pad frame, where the build-up sits.
-
2 Clean
The inside of the cooler is cleaned by hand, corners and tank included.
-
3 Rinse
Everything is rinsed through and the dirty water is flushed out of the unit.
-
4 Test
The finished cooler is run with water flowing over the pads and checked before we leave.
More than an inspection
A proper evaporative service, not just a quick check
A lot of "services" are a look, a hose over the pads and a tick on a form. Ours is a physical clean of the cooler followed by the checks that decide whether it will actually cool your house in January.
A deep foaming clean, not a hose-down
Most services stop at spraying the pads. We apply a foaming cleaning solution to the pads and the relevant internal areas of the cooler, work it through, and rinse it out. That is what lifts the dirt and debris that a quick rinse leaves behind.
The water system is checked, not glanced at
Pump, float valve, drain valve, solenoid, water lines and bleed rate. These are the parts that fail in January, and they are checked and adjusted while the unit is open.
Airflow and operation are tested
Fan modes and speeds, accessible ducting, airflow at the outlets and water distribution across every pad, finished with a full function test so the cooler leaves our hands running the way it should.
Filtrex treatment included
A Filtrex cleaning treatment is applied as part of the service process once the pads and tank are clean.
Everything in the service
What's included, in full
Cleaning
- Deep foaming clean of the pads and relevant internal areas
- Clean filter pads of dust, dirt and debris
- Clean the internal water tank
- Clear debris from the unit
- Check water distribution across the filter pads
Water system
- Check water pump operation and clear debris
- Inspect drain valve for correct operation and leaks
- Check float valve for correct water level where applicable
- Inspect solenoid valve operation
- Test water line and drain pipe for leaks
- Adjust bleed-rate settings where applicable
Airflow and system operation
- Test fan modes and set speeds correctly
- Inspect accessible ducting for condition and airflow
- Check outlets for airflow
- Check water distribution
- Perform a full function test
Roof and drainage
- Inspect roof flashings around the cooler
- Clear relevant debris
- Inspect visible water and drainage components
Some components can only be inspected where access allows. Anything that needs a part, such as a pad set or a pump, is quoted before we fit it, never added to the bill.
Website-only offer $279 SAVE $50!
Book for $279Brands we service
Experienced across all major evaporative cooling brands
Our technicians service and repair these evaporative coolers week in, week out. If your brand is not listed, ask: we can usually help.
Brands shown are serviced by our own technicians. Dealer relationships are stated only where they apply.
Plain answers
Why an evaporative cooler needs a proper service
Dirt and debris build up over a year
A cooler sits on the roof through autumn and winter collecting dust, leaves and grit in the pads, the tank and the frame. That build-up blocks airflow and stops the pads wetting evenly, which is why a cooler that ran well last summer can feel weak this year.
Pads have a working life
Cooling pads wear, clog with minerals and go hard. We check their condition properly and tell you honestly whether they will do another summer or whether a new set is the better money.
The water system is where most faults start
Pumps that stop lifting water, float valves that stick, drain valves that leak and bleed rates that were never set. Each one shows up as a cooler that runs but does not cool, or a roof that stays wet.
Airflow is the whole point
Fan speeds, ducting condition and outlet airflow decide how much cool air reaches the rooms. We test it rather than assume it.
Smells at start-up
A musty smell on the first hot day is usually stale water and a build-up on the pads after months of sitting. A proper clean of the tank and pads deals with the cause rather than masking it.
Ready before the heat, not during it
The first hot week is when every cooler in the district gets switched on and the breakdown calls start. A spring service picks up the obvious problems while there is still time to fix them without a wait.
Local knowledge
Evaporative cooling in Bulla
Bulla is a small township on Deep Creek with semi-rural blocks around it. The summers are hot and dry, which suits evaporative cooling, and the open blocks bring wind and dust, which is what a Bulla cooler needs cleaned out of it every spring. Our technicians are our own employees, factory trained on Brivis and experienced with every major brand.
The service
Tank cleaned, pads inspected and cleaned or quoted, pump tested under load, float and dump valves checked so the unit fills and empties properly, water distribution checked across every pad, fan and motor tested, controller checked and a full run in every mode with the airflow measured at the outlets. The price is agreed before we start and any parts are quoted before they are fitted. Booking through the website brings the website booking price; the main evaporative service page has the offer in full.
Repairs and replacement
If the cooler has stopped or runs without cooling, tell us the symptom and the technician brings the likely parts. Pumps, floats, dump valves, controllers and dusty, scaled pads are the usual Bulla repairs. Where a cabinet is brittle, a tank leaks or the control board is no longer supported, we say a repair is not good money and quote a changeover instead; the Sunbury evaporative cooler replacement page describes the job, which is the same in Bulla. Our guide on a cooler that runs but does not cool covers the checks you can make yourself first.
Other cooling and heating in Bulla
For refrigerated cooling on a larger Bulla home, or a split system for a shed or studio, and for households replacing a gas ducted heater under the VEU program, the Bulla area page points to the right pages.
Plains weather, open blocks
Bulla shares Sunbury's hot, dry summers, so evaporative cooling suits it well, and the open semi-rural blocks around the township take plenty of wind and dust. Dust in the tank and on the pads is the usual reason a Bulla cooler is passing warm air by January, and the tank clean and pad check are where a service earns its keep here.
Acreage coolers
Many Bulla homes sit on larger blocks, often with a shed or studio that has its own cooling. Coolers on the bigger houses can serve long duct runs, and when the far rooms never cool it is usually the ducts rather than the unit. We check the roof before replacing parts on guesswork.
Book the service before the heat
A Bulla cooler that is cleaned and checked in spring runs through the first hot spell instead of failing in it. Pads that have scaled over, a pump that is only just lifting water and a float that sticks are all found on the service, and a pad set or a pump is quoted before it is fitted.
Our own technicians
The technicians who service Bulla coolers are our own in-house team, at the same prices as Sunbury, and the common pumps, floats and pad sets are carried on the van.
Why people book us
The safer choice for your cooler
Our own technicians, every time
A fully in-house team. Nobody is subcontracted, so the person on your roof is one of ours and answers to us.
Evaporative is core work, not a sideline
Brivis, Braemar, Bonaire, Coolair and Breezair coolers come through our books every week of the season, so the faults and the fixes are familiar.
Based in Sunbury, servicing Bulla
Our depot is in Sunbury and our own technicians regularly service Bulla and the surrounding area.
No surprises on the day
The service price is confirmed when the booking is confirmed. Anything extra, such as a pad set or a pump, is quoted before it is done, never added to the bill.
Factory-trained dealers
Trained by the manufacturers, buying direct
We are factory-trained dealers for ActronAir, Brivis and Rinnai and purchase equipment directly from these manufacturers.
Ready to book?
Ready to book your evaporative cooling service?
$279 website offer ends in
This week's website offer ends Monday 5:00 am, Melbourne time.
This is a booking request. Our team confirms the day and time with you.
Get in touch
Send your booking request
Tell us where you are and anything we should know about the cooler. Our team confirms the appointment with you.
Prefer to talk? Call 1300 369 400, monday to friday 8:00am to 5:00pm, Saturday 9:00am to 1:00pm.
What happens next
Evaporative cooling in Bulla: your questions
What does a Bulla evaporative cooling service include?
The tank is drained and cleaned, the pads are inspected and cleaned or quoted for replacement, the pump and the float and dump valves are tested, water distribution across every pad is checked, the fan and motor are tested under load, the controller and connections are checked and the unit is run through every mode with the airflow checked at the outlets. You get a written note of anything that will need attention. The website booking price on the main evaporative service page applies when you book online.
Is Bulla far enough from Sunbury to cost more?
No. Bulla is priced the same as Sunbury.
Do you carry parts for a first-visit repair?
Yes. Pumps, floats, dump valves and pad sets for the common Brivis, Braemar and Bonaire models are carried, so most Bulla repairs are finished on the first visit.
If my cooler is past it, do you replace it?
Yes. When a cabinet has gone brittle, the tank leaks or the control board is obsolete, we quote a changeover with a new cooler sized for the house and installed by our own team. The Sunbury changeover page describes the job.